THE SERIES R212 IS DESIGNED TO RETRO-FIT FIXTURES THAT ARE OF LENGTHS OF 24, 36, 48 AND 98
INCHES PLUS OR MINUS 1/32 OF AN INCH.  STRIP FIXTURE WIDTHS CAN VERY FROM 3 INCHES
TO 5 INCHES.   THE R212 IS DESIGNED TO RETRO-FIT CHANNEL HOUSINGS WITHOUT TURRET BOXES
OR  HOUSINGS THAT HAVE NOTCHES ALLOWING ACCESS TO INTERNAL WIRING.  IF TURRETED HOUSING IS TO BE RETRO-FITTED USE A COVER PLATE TO COVER ANY ACCESS TO THE INTERNAL WIRING OR LAMP HOLDERS.

TURN OFF POWER TO FIXTURE BEING RETROFITTED.

REMOVE EXISTING LAMPS.

REMOVE EXISTING BALLAST / WIRE WAY COVER(S).

CUT POWER LEADS TO EXISTING BALLAST.

REMOVE EXISTING SOCKET PLATES.

REMOVE EXISTING BALLAST (DISPOSE IN ACCORDANCE WITH LOCAL CODES).

"TEK" SCREW MOUNTING ANGLE TO TOP OF HOUSING, INDEXING OFF 7/8" KNOCK OUT,
PULL 2 - 3 INCHES OF BEAD-CHAIN THROUGH KEY-HOLE SLOT IN MOUNTING ANGLE AND SECURE.

CONNECT BALLAST LEADS AND GROUND TO APPROPRIATE EXISTING CONNECTIONS THEREIN
EXISTING HOUSING. GROUNDING  CAN BE ACCOMPLISHED BY CONNECTING THE R212 GREEN GROUND WIRE TO THE EXISTING HOUSING GREEN GROUND WIRE VIA WIRE NUT OR SECURING R212 GREEN GROUND WIRE TO THE INCOMING POWER SUPPLY GROUND VIA WIRE NUT.  WHEN NO GROUND WIRE IS FOUND ON EXISTING HOUSING USE PROPER GROUNDING TECHNIQUE TO SECURE THE R212 GREEN GROUND WIRE TO A GROUNDED PORTION OF THE EXISTING HOUSING.

ONCE CONNECTION IS MADE PRESS R212 TIGHTLY AGAINST EXISTING HOUSING AND SECURE BY
PULLING CHAIN THROUGH HOLE.  ONCE HOUSING IS SNUG, SECURE CHAIN BY SLIDING INTO SLOT.

WHEN HOUSING IS SECURE COIL EXCESS BEAD-CHAIN INTO CAP AND PUSH ARROW CLIP
INTO HOLE IN HOUSING.

TO REMOVE CAP PULL LIGHTLY AND DISENGAGE ARROW CLIP.

ALIGNMENT OF CONSECUTIVE RETROFIT ASSEMBLIES CAN BE ACCOMPLISHED BY COUPLING ENDS
TOGETHER USING THE SUPPLIED BAYONET ALIGNER.

INSTALL LAMPS AND TURN ON POWER.